Extreme Networks Summit1 manual Configuring QOS, 4QoS Configuration Commands

QUALITY OF SERVICE (QOS)

CONFIGURING QOS

Table 8-4describes the commands used to configure QoS.

Table 8-4:QoS Configuration Commands

Command	Description
enable pace	Enables recognition of the PACE bit.
	Available in ingress mode, only.
create qosprofile <qosname>	Creates a QoS profile. The default values
	assigned to a created QoS profile are:
	■ Minimum bandwidth — 0%
	■ Maximum bandwidth — 100%
	■ Priority — low
config qosmode [ingress egress]	Changes the QoS mode to ingress mode
	or egress mode.
config qosprofile <qosname> {minbw <percent>}	Configures a QoS profile. Specify:
{maxbw <percent>} {priority <level>}	■ minbw — The minimum bandwidth
	percentage guaranteed to be available
	to this queue. The default setting is 0.
	■ maxbw — The maximum bandwidth
	percentage this queue is permitted to
	use. The default setting is 100.
	■ priority — The service priority for
	this queue. Settings include low,
	medium-low, medium, high. The default
	setting is low. Available in egress mode,
	only.
config port <portlist> qosprofile <qosname>	Allows you to configure one or more ports
	to use a particular QoS profile. Available
	in ingress mode, only.
config vlan <name> qosprofile <qosname>	Allows you to configure a VLAN to use a
	particular QoS profile.
disable pace	Disables recognition of the PACE bit.
	Available in ingress mode, only.

8-8 SUMMIT SWITCH INSTALLATION AND USER GUIDE