Extreme Networks Summit1 manual Saving Changes, Standalone Buttons

SAVING CHANGES

Table 13-1:Multi-Select List Box Key Definitions (continued)

Selection Type	Key Sequence
Selected non-contiguous items	Hold down [Control], click the first
	desired item, click the next desired
	item, and so on.

STATUS MESSAGES

Status messages are displayed at the top of the content frame. There are four types of status messages, as follows:

•Information—Displays information that is useful to know prior to, or as a result of, changing configuration options.

•Warning—Displays warnings about the switch configuration

•Error—Displays errors caused by incorrectly configured settings

•Success—Displays informational messages after you click Submit. The message displayed reads, “Request was submitted successfully.”

STANDALONE BUTTONS

At the bottom of some of the content frames is a section that contains standalone buttons. Standalone buttons are used to perform tasks that are not associated with a particular configuration option. An example of this is the Reboot Switch button.

SAVING CHANGES

There are two ways to save your changes to non-volatile RAM storage using ExtremeWare Vista:

•Select Save Configuration from the Configuration task tab, Switch option.

This field contains a drop-down list box that allows you to select either the primary or secondary configuration area. After you select the configuration area, click Submit to save the changes.

For more information on the primary and secondary configuration areas, refer to Chapter 14.

SUMMIT SWITCH INSTALLATION AND USER GUIDE 13-5