CONFIGURING IP MULTICASTING ROUTING

Enable DVMRP on the router, using the following command: enable dvmrp

Table 11-1describes the commands used to configure IP multicast routing.

Table 11-1:IP Multicast Routing Configuration Commands

Command

Description

 

 

enable dvmrp

Enables DVMRP on the switch. The default

 

setting is disabled.

enable ipmcforwarding {<vlan <name> all>}

Enables IP multicast forwarding on an IP

 

interface. If all is specified, all configured IP

 

interfaces are affected. When new IP interfaces

 

are added, ipforwarding is disabled by default.

config dvmrp add {vlan <name> all}

Enables DVMRP on an IP interface. When an IP

 

interface is created, DVMRP is enabled by

 

default.

config dvmrp delete {vlan <name> all}

config dvmrp vlan <name> timer <probe_interval> <neighbor_timeout_interval>

Disables DVMRP on an IP interface.

Configures DVMRP interface timers. Specify the following:

probe_interval — The amount of time that the switch waits between transmitting DVMRP probe messages. The range is 1 to 4294967296 seconds (136 years). The default setting is 10 seconds.

neighbor_timeout_interval — The amount of time before a DVMRP neighbor route is declared to be down. The range is 1 to 4294967296 seconds (136 years). The default setting is 35 seconds.

SUMMIT SWITCH INSTALLATION AND USER GUIDE

11-3

Page 171
Image 171
Extreme Networks Summit1 manual 1IP Multicast Routing Configuration Commands, Command Description