
| CONFIGURING RIP |
Table | |
|
|
Command | Description |
|
|
config rip add {vlan <name> all} | Configures RIP on an IP interface. If no VLAN |
| is specified, then all is assumed. When an |
| IP interface is created, per interface RIP |
| configuration is disabled by default. |
config rip delete [vlan <name> all] | Disables RIP on an IP interface. When RIP is |
| disabled on the interface, the parameters are |
| not reset to their defaults. |
config rip garbagetime {<delay>} | Configures the RIP garbage time. The timer |
| granularity is 10 seconds. The default setting is |
| 120 seconds. |
config rip routetimeout {<delay>} | Configures the route timeout. The timer |
| granularity is 10 seconds. The default setting is |
| 180 seconds. |
config rip rxmode [none v1only v2only any] {vlan <name> all}
config rip txmode [none v1only v1comp v2only] {vlan <name> all}
Changes the RIP receive mode for one or more VLANs. Specify:
■none — Drop all received RIP packets.
■v1only — Accept only RIP version 1 format packets.
■v2only — Accept only RIP version 2 format packets.
■any — Accept both version 1 and version 2 packets.
If no VLAN is specified, the setting is applied to all VLANs. The default setting is any.
Changes the RIP transmission mode for one or more VLANs. Specify:
■none — Do not transmit any packets on this interface.
■v1only — Transmit RIP version 1 format packets to the broadcast address.
■v1comp — Transmit version 2 format packets to the broadcast address.
■v2only — Transmit version 2 format packets to the RIP multicast address
If no VLAN is specified, the setting is applied to all VLANs. The default setting is v2only.
SUMMIT SWITCH INSTALLATION AND USER GUIDE |
|