VIRTUAL LANS (VLANS)
VLANs that are automatically created using GVRP with the VLANid 10 are given names in the following format:
gvrp vlan xxxx
where xxxx is the VLANid (in decimal) that is discovered by GVRP. These VLANs are not permanently stored in NVRAM, and you cannot add or remove ports from these VLANs.
GVRP assumes that the VLANs for which it carries information operate using VLAN tags, unless explicitly configured otherwise. Typically, you must configure any untagged VLANs on the switches at the edges of the network, and the GVRP protocol is used across the core of the network to automatically configure other switches using tagged VLANs.
GVRP COMMANDS
Table
Table 5-1: GVRP Commands
Command | Description |
|
|
enable gvrp | Enables the Generic VLAN Registration |
| Protocol (GVRP). The default setting is |
| disabled. |
config gvrp {listen send both none} {port <portlist> all}
disable gvrp
Configures the sending and receiving GVRP information on one or more ports. Options include the following:
■listen — Receive GVRP packets.
■send — Send GVRP packets.
■both — Send and receive GVRP packets.
■none — Disable the port from participating in GVRP operation.
The default setting is both.
Disables the GARP VLAN Registration Protocol.
show gvrp | Displays the current configuration and status |
| of GVRP. |
|
|
SUMMIT SWITCH INSTALLATION AND USER GUIDE |
