HP 5100LE manual Reinstallation of Tray 2 shaft

To reinstall

1Tip the printer back, so that the front faces up.

2Insert the shaft into the fitting on the right side. Then, angle the shaft into the other side.

3Place the bushing on the right end of the shaft, and push until the tab locks in the indentation on the shaft.

4Facing the left side of the printer, orient the shaft so that the open end of the shaft (callout 3) points away from the solenoid arm.

5Depress the solenoid arm, and slide the gear into place. Press the gear into the plastic collar until it locks in place.

6Reinstall the spring on the arm of the gear.

3

Figure 86. Reinstallation of Tray 2 shaft

Q1860-90918 6 Removing and replacing parts 153

www.GovTechMedia.com