HP 5100LE manual If an optional duplexer is installed

108Removing and replacing parts

6Slide the formatter board back into the printer and tighten the two captive screws.

7If an optional duplexer is installed, reattach the cable tray and the rear section of the duplexer. Reattach any interface cables and the power cord. Turn the printer on and test the DIMM (see page 109).

If an optional duplexer is installed:

1Slide the rear section of the duplexer away from the printer.

2Remove the rear section of the duplexer by lifting and rotating the rear section to clear all of the tabs from the grooves.

3Unplug the power cord and disconnect any cables.

4Remove the cable tray by lifting it out of position.

5Go back to step 2 on page 107.

Note

Reverse these steps to reinstall the cable tray and the rear section of the duplexer. Make sure that the cable tray is properly installed and the cables are routed through the left side.

Q1860-90918

www.GovTechMedia.com