4Remove the four self-tapping screws (callout 2) inside the chassis.

Note

Lift up the small green handle of the registration assembly to gain access to two of these screws.

2

Figure 93.Registration assembly removal (2 of 2)

5Lift the registration assembly out of the chassis.

To reinstall

When you reinstall the registration assembly, be careful to align the flags in the base as you reinstall the assembly.

When you reinstall the clutch, orient the flat spot in the shaft with the clutch. When you slide the clutch on the shaft, make sure that the metal alignment tab is seated on the printer frame. Also make sure that the cable is situated away from the registration assembly.

160 Removing and replacing parts

Q1860-90918

www.GovTechMedia.com

Page 162
Image 162
HP 5100LE manual Registration assembly removal 2