HP 5100LE manual Covers, Rear door and rear output bin removal 2

Covers

Rear door and rear output bin

1Face the rear of the printer. Press the two locking tabs (callout 1) toward the center of the printer to release the rear door.

1

Figure 37. Rear door and rear output bin removal (1 of 2)

2The plastic support strap is located on the left side of the printer. To release the strap, pinch the top of the strap by placing your index finger underneath the strap and your thumb on top of the tab. Squeeze and lift up from the bottom, while pulling the strap out.

Figure 38.	Rear door and rear output bin removal (2 of 2)
	3 Slide the door to the left, and then remove it from the printer.
Note	For reassembly, insert the pin on the left side of the cover first.
	6 Removing and replacing parts 113
Q1860-90918

www.GovTechMedia.com