HP 8360 manual Use of the Command Tables, Sample Synthesizer Commands

Use of the Command Tables

In Table 1-4, notice that a new column titled “Allowed Values” has been added to the command table. This column lists the specific values or range of values allowed for each parameter. A vertical bar (I) separates values in a list from which you must choose one value. The commands listed in the table are only part of all the available SCPI commands of the synthesizer. For a complete listing of the programming codes see “SCPI Command Summary” in the Operating and Programming Reference chapter that follows.

Table 1-4. Sample Synthesizer Commands

Command	Parameters		Parameter Type	Allowed Values
:CALibration
:PMETer
:FLATness
:INITiate?	flatness array		discrete	USER]DIODE]PMETer]MMHead
	to cal
:NEXT?	measured	power	extended numeric	<num> [lvl suffix]
CORRection
:FLATness	801 freq-		extended numeric	{ <num> [freq suffix],
	correction	pairs		DB}2*801
FREQuency
:CENTer	center freq		extended numeric	specified freq
				range
				~AXimum]MINimum/UP]DOWN
[:CW]	CW freq		extended numeric	specified freq range
				or MAXimum]MINimum]UP]DOWN
:AUTO	coupled to		Boolean	ON]OFF]l]O
	center freq
:MODE	free mode		discrete	CW]SWEep]LIST
:STARt	start freq		extended numeric	specified freq range
				or MAXimum]MINimum]UP]DOWN
:STEP
:AUTO	auto freq step		Boolean	ON]OFF]l]O
[:INCRement]	freq step		extended numeric	20 to 0.01 dB or
				MAXimumlMINimum
:STOP	stop freq		extended numeric	specified freq range
				or
				MAXimum]MINimum]UP]DOWN
MARKer[n]				[n] is 1 to 5, 1 is the default
:FREQuency	marker frequency		extended numeric	specified freq range
				or MAXimumlMINimum

Getting Started Programming 1-87