HP 8360 Module Select Front, User’s, M-24Operating and Programming Reference

Module Select AUTO

Function Group

Menu Map

Description

POWER and FREQUENCY

2 and 5

This command sets the automatic selection of the millimeter source module interface connector. The synthesizer looks at both front and rear connectors and determines the type of source module

(if any) connected. If a source module is present at both connectors, the synthesizer selects the front connector as the active one. After selecting the interface the instrument frequency limits and multiplier are altered accordingly. However, the leveling point is not changed. See Leveling Point Module to set the synthesizer to level at the output of the source module.

An asterisk next to the key label indicates this feature is active. This feature is the default after preset.

Programming Codes

See Also

SCPI:

SYSTem:MMHead:SELect:AUTO ONJOFFJ110 SYSTem:MMHead:SELect:AUTO?

Analyzer: NONE

Module Menu

Module Select Front

Function Group

Menu Map

Description

POWER and FREQUENCY

2 and 5

This command causes the synthesizer to examine only the front panel source module interface connector to determine the type of source module (if any) connected. The instrument frequency limits and multiplier are altered according to the source module connected. However, the leveling point is not changed. See Leveling Point Module to set the synthesizer to level at the output of the source module.

An asterisk next to the key label indicates this feature is active.

M-24 Operating and Programming Reference	HP 8360
User’s	Handbook