
SCPI COMMAND SUMMARY
positions to the bandwidth, < 20 Hz and > 100 kHz, but any numeric is accepted. The value is compared to 1 kHz and the correct position is determined (> 1 kHz sets the position to 100 kHz and
5 1 kHz sets the position to 20 Hz). After *RST, the value is 100 kHz.
•FM:INTernal:FREQuency <num>[freq suffix] IMAXimumlMINimum
•FM:INTernal:FREQuency? [MAXimumlMINimum]
Sets and queries the frequency (in Hz) of the internal FM source.
After *RST, the value is 1 MHz.
•FM:INTernal:FUNCtion SINusoid~SQUarelTRIagleiRAMPlNOISe
•FM:INTernal:FUNCtion?
Sets and queries the waveform of the internal FM source.
After “RST, the value is SINusoid.
•FM:SOURce INTernallEXTernal
•FM:SOURce?
Sets and queries the source of the FM modulating signal.
After *RST, the value is EXTernal.
•FM:SENSitivity <num>[freq suffix/V] lMAXimumlMINimum
•FM:SENSitivity? CMAXimumIMINimum]
Sets and queries the FM Input sensitivity.
The *RST value is MAX (10 MHz/V) .
•FM:STATe ONlOFFlllO
•FM:STATe?
Sets and queries the FM modulation state.
After *RST, the value is OFF.
Frequency Subsystem | Any two frequency setting headers (STARt, STOP, CENTer, or |
| SPAN) may be sent in a single message and the resulting sweep |
| is what was requested. The order of the headers in the message |
| does not make any difference in the final result. When a message is |
| completed, coupling equations are used to fix the unset parameters to |
| the correct values. These equations specify that: |
| center frequency = (start + stop) / 2 |
| frequency span = (stop - start) |
| If more than two are sent then the last two in the message are used |
| to determine the sweep and no errors are given. |
| If only one header is sent in a message, then the assumed pairs are |
| center/span and start/stop. In other words, if only center is sent, |
| then span is kept constant (if possible) while adjusting center to the |
| requested value. The start/stop frequencies are updated to reflect the |
| changes based on the coupling equations. |
HP 8360 | Operating and Programming Reference |
User’s Handbook |
|