
Note | Two terms are used in the following discussions: power output and |
| ALC level. Power output means actual output power including the |
| effects of the attenuator. ALC level means power levels before the |
| attenuator. In synthesizers without attenuators, these two terms are |
| equivalent. |
|
|
| Internal Leveling - Leveling Mode Noxrnal, |
| L e v e l i n g P o i n t Intrnl |
| In this configuration (Figure |
| internal to the synthesizer and a dc output from this detector is fed |
| back to the Level Control Circuits. |
| The ALC level is limited at the low end by the Level Control Circuits |
| and at the high end by maximum available power. Noise and |
| drift limit the range at the low end to |
| combination of RF frequency and RF components (different models |
| of synthesizer have different RF components) limit the ALC range |
| available at the high end. The internal instructions (firmware) of |
| the synthesizer limit the ALC level range available for request from |
| |
| synthesizer is capable of producing, the maximum available power is |
| produced, and the message line displays UNLVLED (unleveled). When |
| the synthesizer performs frequency sweeps at certain ALC levels, |
| maximum available power can be exceeded during small portions of |
| the sweep; in this case, a flashing UNLVLED message appears. |
| ALC leveling accuracy depends on power level. Although the ALC |
| level is useable from |
| |
| specifications of the synthesizer. |
| Coupled Operation. Since many applications require power output |
| less than |
| 0 to 90 dB, in 10 dB steps. With this option, power output down |
| to |
| Control Circuits work in conjunction (see Figure |
| attenuator, the ALC level is normally used over the smaller, more |
| accurate portion of its range. Since ALC level accuracy suffers below |
| |
| available, the ALC level is set between |
| less than |
| level is used from |
| output above 0 dBm is desired, the attenuator is set to 0 dB, and the |
| ALC level is used from 0 to +25 dBm (or whatever power is available |
| at the RF frequency in use). |
| Coupled operation is assumed by the synthesizer unless |
| Uncoupl Atten or Leveling Mode ALCoff is selected. The proper |
| combination of ALC level’and attenuator setting is decided by the |
| firmware. In coupled operation, when desired power output is set via |
| HP 8360 |
User’s | Handbook |