HP 8360 manual User, Operating and Programming Reference S-29

HP 8360

User’s Handbook

SCPI COMMAND SUMMARY

If this is ON, each time a frequency or power is changed, CALibration:AM[:EXECutel is attempted.

•CALibration:AM[:EXECutel

When AM is on and the synthesizer is in the CW or manual mode, the synthesizer performs a modulator calibration as long as power sweep is not active.

•CALibration:PEAKing:AUTO ONlOFFlllO

•CALibration:PEAKing:AUTO?

Sets and queries the automatic peaking function. If AUTO is ON, then a peak is done at regular intervals automatically. After *RST, the setting is OFF.

•CALibration:PEAKing[:EXECute] Peaks the SYTM.

•CALibration:PMETer:DETector:INITiate? IDETectorlDIODe Initiates the specified calibration. These calibrations require the use of an external power measurement. Once initiated, the synthesizer sets up for the first point to be measured, and responds to the query with the frequency at which the power is to be measured.

The parameters mean:

IDETector	Initiates a	calibration of the internal detector logger
	breakpoints	and offsets.
DIODe	Initiates a	calibration of an external detector’s logger
	breakpoints	and offsets.

•CALibration:PMETer:DETector:NEXT? Cnum>[lvlsuffix]

The parameter is the measured power that is currently produced by the synthesizer. You must supply this parameter after measuring the power using an external power meter. The query response is issued after the synthesizer processes the supplied parameter and settles on the next point to be measured. The query response is:

>o The frequency [in Hz] that is currently produced.

0 The calibration is complete.

<o An error has occurred and the calibration is aborted.

•CALibration:PMETer:FLATness:INITiate? USERlDIODelPMETerlMMHead

Initiates the specified calibration. These calibrations require the use of an external power measurement. Once initiated, the synthesizer sets up for the first point to be measured, and responds to the query with the frequency at which the power is to be measured.

The parameters mean :

USER Initiates a calibration at all of the user flatness points.

Operating and Programming Reference S-29