HP 8360 User’s Handbook, Operating and Programming Reference S-17

HP 8360

User’s Handbook

SWEep : STEP value is (StopMAX-StartMIN) /lO

SWEep:TIMEMINimum

SWEep:TIME:AUTO ON

SWEep:TIME:LLIMit 10ms

SWEep : GENerat ion ANALog

SWEep : MODE AUTO

SWEep : MANual : POINt 1

SWEep:MANual[:RELative] 0.50

SWEep:MARKer:STATe OFF

SYSTem: ALTernate 1

SYSTem:ALTernate:STATe OFF

SYSTem:COMMunicate:GPIB:ADDRess 19

SYSTem:KEY:ENABle SAVE

SYSTem:MMHead:SELect:AUTO ON

SYSTem:SECurity:COUNt 1

UNIT:AMPCT *UNIT:POWerDBM

•*SAV <num>

The present instrument state is stored in the specified memory register. The acceptable numeric range is from 1 to 8. An execution error occurs if you try to save state 0.

•*SRE <num> • *SRE?

Sets and queries the value of the Service Request Enable Register.

•*STB?

Queries the Status Byte. This is a non-destructive read.

•*TRG

This command performs the same function as the Group Execute Trigger command defined by IEEE 488.1.

•*TST?

A full selftest is performed, without data logging or looping, and returns one of the following error codes:

Error Code Definition

0Test passed.

1Test failed.

2Test not run yet. (This is an unlikely event.)

3Test aborted.

4Can not execute the test.

5Can not execute the test, test skipped.

-1Unrecognized result, software defect.

a *WA1

This causes the synthesizer to wait for the pending commands to be completed before executing any other commands. For example,

Operating and Programming Reference S-17