Using SCSISelect with SCSI Devices

The Ultra160 and faster SCSI host adapters include the SCSISelect utility to configure the host adapter and to run the SCSI disk utilities. To run the SCSISelect utility:

NOTE: The onboard LSI SCSI controller on the xw9300 has an “LSI Logic Configuration Utility” that you access through Ctrl-Cwhen the LSI option ROM is initializing.

In POST Messages Enabled mode: Press Ctrl+A when the “Press<Ctrl><A> for SCSISelect Utility” message appears during POST. The utility will only be present if an Adaptec SCSI card is present.

In POST Messages Disabled mode: When the HP logo screen appears, press any key to exit the logo screen. Immediately after exiting the logo screen, press Ctrl+A to access the SCSISelect utility. The utility will only be present if an Adaptec SCSI card is present.

A menu appears with the following options:

Configure/View Host Adapter Settings

SCSI Bus Interface Definitions

Host Adapter SCSI ID

SCSI Parity Checking

Host Adapter SCSI Termination

Additional Options

Boot Device Options

SCSI Device Configuration

Advanced Configuration Options

SCSI Disk Utilities

Lists all SCSI devices and SCSI ID numbers

NOTE: For additional information about configuring POST message display status, refer to “Computer Setup Menu” on page 47.

SCSI Devices A

Using SCSISelect with SCSI Devices 173

Page 173
Image 173
HP xw9300 manual Using SCSISelect with Scsi Devices