HP Z220 F1J90UAABA, Z420 D3J34UT#ABA, B2B94UT B2B94UT#ABA, B5P07UT B5P07UT#ABA Setup F10 Utility

Table 2-2Computer Setup (F10) Utility menu descriptions for the HP Z420, Z620, and the Z820 Workstations (continued)

Heading	Option	Description
Advanced2	Power-On Options	Enables you to set the following:
		● POST Messages—Enables or disables the splash screen during POST.
		● Press the ESC key for Startup Menu.
		● Option ROM1 prompt (Enable or Disable)—Enabling this feature causes the
		workstation to display a message before loading options ROMs.
		● After Power Loss (On, Off, Last State)—Enabling this option directs the previous state
		to be the default.
		● POST Delay (in seconds) (5, 10, 15, 20, None)—Adds a specified delay to the POST
		process. This delay is sometimes needed for hard disk drives on some expansion
		cards that spin up slowly (so slowly that they are not ready to start by the time POST
		is finished). The POST delay also gives you time to select F10 to enter the Computer
		Setup (F10) Utility.
		● Remote Wakeup Boot Source—Enables you to set the remote wakeup boot source as:
		◦	Local Hard Drive
		◦	Remote Server
		● Bypass F1 Prompt on Configuration Changes.
	BIOS Power-On	Enables you to disable or specify a weekday and time for BIOS power-on.
	Onboard Devices	Enables you to set resources (IRQ, DMA, I/O Rate) for or disable onboard system devices
		such as serial port and diskette controller. Operating system parameters generally override
		Onboard Devices settings.
	Bus Options	Configures graphics cards per workstation slots. In multi-graphics card configurations, this
		option designates one card as primary graphics, and the other card as secondary
		graphics.

● Numa—(Enable or Disable)

● SERR# Generation (Enabled/Disabled)—Controls PCI SERR# generation for ill- behaved PCI add-in cards (that can generate SERR# spuriously)

● VGA Palette Snoop (Disabled/Enabled)—Controls PCI VGA Palette Snooping for compatibility purposes

● PCI Latency Timer—(32/64/128/160/192/224/248). 128 PCI Clocks is the default.

58 Chapter 2 System management