Menu item
Run Initial setup
Yes
No
Paper Sizes
U.S.
Metric
Scan to PC Port Range
<port range>
Default Mode
Copy
Fax
Date Format
Time Format
12 hour A.M./P.M.
24 hour clock
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Power Saver Disabled
Timeouts
Screen Timeout
Description
Instructs the printer to run the setup wizard
Notes:
•Yes is the factory default setting.
•After completing the setup wizard by selecting Done at the Country select screen, the default setting becomes No.
Specifies the printer factory default measurements. The default setting is determined by the country selection in the initial setup wizard.
Specifies a valid port range for printers behind a port blocking firewall. The valid ports are specified by two sets of numbers separated by a semicolon.
Note: 9751:12000 is the factory default setting.
Sets the function the printer enters when Go, Content, Darkness, or any number is pressed on the printer control panel
Note: Copy is the factory default setting
Formats the printer date
Note:
Formats the printer time
Note: The factory default setting is 12 hour A.M./P.M.
Sets an alarm to sound when the printer requires operator intervention. Available selections for each alarm type are:
Off Single Continuous
Notes:
•Single is the factory default setting for Alarm Control. Single sounds three quick beeps.
•Off means no alarm will sound.
•Continuous repeats three beeps every 10 seconds.
Specifies the number of minutes of inactivity before some systems begin entering a minimum power state.
Note: 30 minutes is the factory default setting.
Sets the amount of time in seconds the printer waits before returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Understanding printer menus
