When you have finished, file the form with the rest of the planning forms.
o
o Obtain Non-Local UDP Administration Form in the Installation Specification, UDP Routing.
o Plan changed or new non-local UDP routes using the planning guidelines above and after consulting other system managers in the private network. Record the new values on the form.
o Ensure that tandem trunks have been assigned to pools. If necessary, consult “Trunks to Pools Assignment” in the “Lines and Trunks” section of System Programming.
NOTE:
To avoid confusion and for future planning purposes, tandem trunks and pools of tandem trunks should be numbered uniquely and unambiguously.
o Open the System Programming menu from the console or a PC with SPM.
o Program the change(s), following the instructions below in the order shown, or those for “UDP Routing” in System Programming.
Task List: Uniform Dial-Plan Routing
5
For UDP routing, the voice/data attribute is used in conjunction with PRI tandem trunks.
The voice/data attribute can be associated with any UDP route. The factory setting is Voice/Data.
Valid Entries
Voice Only, Data Only, Voice/Data

MERLIN LEGEND Communications System Release 6.1

Issue 1

Network Reference 555-661-150

August 1998

5 Network Management

 

Uniform Dial Plan Routing

Page 5-29

 

 

Special characters such as *, Stop, and # cannot be included as extra digits.

Pause is allowed in every position but the first.

NOTE:

Digit absorption is applied before digit prepending.

The factory setting is empty.

Valid Entries

Up to 20 digits (any combination of 0 to 9 and HOLD (P), for Pause)

Voice and/or Data Routing

5

 

 

 

 

 

 

 

 

Page 225
Image 225
Lucent Technologies 555-661-150 manual Voice and/or Data Routing