![](/images/new-backgrounds/1228756/228756119x1.webp)
Table 3-6. SCSISelect Setup Configurations
| Recommended Setting or |
|
Option | Display Only | Your Configuration |
|
| |
|
|
|
SCSI Bus Interface Definitions |
|
|
Host Adapter SCSI ID | 7 |
|
SCSI Parity Checking | Enabled |
|
Host Adapter SCSI Termination | Enabled |
|
Additional Options |
|
|
Boot Device Options | Press Enter for menu |
|
Boot Channel | A First |
|
Boot SCSI ID | 0 7 |
|
Boot LUN Number | 0 |
|
SCSI Device Configuration | Press Enter for menu |
|
Initiate Sync Negotiation | Yes |
|
Maximum Sync Transfer Rate | 40.0 4 |
|
Enable Disconnection | Yes |
|
Initiate Wide Negotiation | Yes 5 |
|
Send Start Unit Command | Yes 1 and 5 |
|
BIOS Multiple LUN Support | no 1 |
|
Include in BIOS Scan | Yes 1 |
|
Advanced Configuration Options | Press Enter for menu. |
|
Reset SCSI Bus at IC Initialization | Enabled |
|
Extended BIOS Translation for DOS Drives | Enabled |
|
>1 GByte |
|
|
Host Adapter BIOS (Configuration Utility | Enabled.1 |
|
Reserves BIOS Space) |
|
|
Support Removable Disks | Boot Only1 |
|
Under BIOS as Fixed Disks 1, 2 |
|
|
Display | Enabled1 |
|
Initialization |
|
|
BIOS Support for Bootable | Disabled1 6 |
|
BIOS Support for INT 13 Extensions | Enabled1 |
|
1No effect if BIOS is disabled.
2Do not remove media from a removable media drive if it is under BIOS control.
3Set to Disable if NetWare 3.12 or 4.11 Network Operating System is installed.
4Set to 40.0 for channel A or 10.0 for channel B.
5Set to Yes for channel A or No for channel B.
6Set to Enabled for channel B or Disabled for channel A.
7Set to 0 for channel A or 5 for channel B.