10.Hook the right side of the support panel into the chassis frame and swing the support panel into position so that the rear edge of the memory boards fits snug against the panel. The support panel is secured to the chassis by two black fasteners. Push in on the support panel fasteners until each clicks in the locked position.
11.Replace the left side panel and turn on the system.
Processors
The following paragraphs provide procedures for installing and removing the Pentium
IIXeon Processor Single Edge Contact (S.E.C.) cartridge. Use these procedures when upgrading or replacing your processor(s). Each processor is packaged in a S.E.C. cartridge. The cartridge includes the processor core with an integrated 16 KB primary (L1) cache, secondary (L2) cache, heat sink, and a back cover. The processors are supported by one or more voltage regulator modules (VRM) on the CPU baseboard, depending on the number of installed processors.
Each S.E.C. cartridge installs in a Slot 2 connector on the CPU baseboard. Each slot must contain either a processor cartridge or a termination board (if there are less than four processors installed). The VRM modules are installed in a bank of VRM sockets adjacent to the processors.
Note: Your system may have up to four processors. All installed processors must be matched for speed. If replacing a processor, the replacement processor must match the speed of all installed processors. If upgrading a processor, all processors must be upgraded to match.
!CAUTION
Electrostatic discharge (ESD) can damage components; place them on an antistatic surface. Update the CPU baseboard using an antistatic wrist strap attached to chassis ground.
