Netopia 3300-ENT manual Adding a static route

Models: 3300-ENT

1 302
Download 302 pages 63.93 Kb
Page 156
Image 156

6-8 Firmware User Guide

Subnet Mask: The subnet mask associated with the destination network.

Next Gateway: The IP address of the gateway that will be used to reach the destination network.

Priority: An indication of whether the Router will use the static route when it conflicts with information received from RIP packets.

Enabled: An indication of whether the static route should be installed in the IP routing table.

To return to the Static Routes screen, press Escape.

Adding a static route

To add a new static route, select Add Static Route in the Static Routes screen. The Add Static Route screen will appear.

Add Static Route

Static Route Enabled:

Yes

Destination Network IP Address:

0.0.0.0

Destination Network Subnet Mask:

0.0.0.0

Next Gateway IP Address:

0.0.0.0

Route Priority...

High

Advertise Route Via RIP:

No

ADD STATIC ROUTE NOWCANCEL

Configure a new Static Route in this Screen.

To install the static route in the IP routing table, select Static Route Enabled and toggle it to Yes. To remove the static route from the IP routing table, select Static Route Enabled and toggle it to No.

Be sure to read the rules on the installation of static routes in the IP routing table. See “Rules of static route installation” on page 6-9.

Select Destination Network IP Address and enter the network IP address of the destination network.

Select Destination Network Subnet Mask and enter the subnet mask used by the destination network.

Select Next Gateway IP Address and enter the IP address for the gateway that the Router will use to reach the destination network. This gateway does not necessarily have to be part of the destination network, but it must at least know where to forward packets destined for that network.

Select Route Priority and choose High or Low. High means that the static route takes precedence over RIP information; Low means that the RIP information takes precedence over the static route.

If the static route conflicts with a connection profile, the connection profile will always take precedence.

Page 156
Image 156
Netopia 3300-ENT manual Adding a static route