Netopia 3300-ENT manual Firmware User Guide

2-8 Firmware User Guide

Note: With multiple VCs you must explicitly statically bind the second (and all subsequent) VCs to a profile. The first VC will automatically statically bind according to pre-defined dynamic binding rules when you add the second VC. It will revert back to dynamic binding if the number of VCs is reduced to one; for example, by deleting previously defined VCs.

When the link comes up the router binds the VC dynamically to the first suitable Connection Profile or to the Default Profile if there is no Connection Profile configured.

•If you factory default the router, the VC binds to the Default Profile.

•If you delete a Connection Profile that is statically bound to a VC, the VC binding is set back to the Default Profile. If there is only one VC defined, the VC dynamically binds to the first suitable profile or to the Default Profile. If there are multiple VCs defined, it binds to the Default Profile.

•If you add a second VC, it is initialized to the Default Profile, and the menu screens display the VC Connection Profile-related items, allowing you to bind to a specific Connection Profile instead of the Default Profile. In addition, the router statically binds the first VC according to the rules used to select a profile for dynamic binding. At this point, each profile uses static binding when the link is brought up.

•If there are no VCs when you add a VC -- for example, if you deleted all your previous VCs and started adding them again -- dynamic binding will occur when the link comes up. If you delete a VC, leaving only one VC, that VC resumes dynamically binding again.

• Select ADD Circuit NOW and press Return.

8.To display or change a circuit, select Display/Change Circuit, select a circuit from the pop-up menu, and press Return. The fields are the same as those in the Add Circuit screen.

9.To delete a circuit, select Delete Circuit, select a circuit from the pop-up menu, and press Return. In the confirmation window, select CONTINUE and press Return.

10.Press Escape to return to the WAN Setup menu.