Netopia 3300-ENT manual IP Setup, Filter Sets, IP Address Serving, Network Address Translation NAT

WAN and System Configuration 2-23

IP Setup

These screens allow you to configure your network’s use of the IP networking protocol.

•Details are given in “IP Setup” on page 6-2.

Filter Sets

These screens allow you to configure security on your network by means of filter sets and a basic firewall.

•Details are given in “Security” on page 9-1.

IP Address Serving

These screens allow you to configure IP address serving on your network by means of DHCP, WANIP, and BootP.

•Details are given in “IP Address Serving” on page 6-17.

Network Address Translation (NAT)

These screens allow you to configure the Multiple Network Address Translation (MultiNAT) features.

•Details are given in “Multiple Network Address Translation” on page 3-1.

Stateful Inspection

Stateful inspection is a security feature that prevents unsolicited inbound access when NAT is disabled. You can configure UDP and TCP “no-activity” periods that will also apply to NAT time-outs if stateful inspection is enabled on the interface. Stateful Inspection parameters are active on a WAN interface only if enabled on your Gateway. Stateful inspection can be enabled on a profile whether NAT is enabled or not.

Stateful Inspection
UDP no-activity timeout (sec):	180
TCP no-activity timeout (sec):	14400
Add Exposed Address List...
Exposed Address Associations...

Return/Enter goes to new screen.

Return/Enter to configure Xposed IP addresses.