2-24 Firmware User Guide
•UDP no-activity time-out: The time in seconds after which a UDP session will be terminated, if there is no
traffic on the session.
•TCP no-activity time-out: The time in seconds after which an TCP session will be terminated, if there is no
traffic on the session.
•Exposed Addresses: The hosts specified in Exposed addresses will be allowed to receive inbound traffic
even if there is no corresponding outbound traffic. This is active only if NAT is disabled on an WAN
interface.
Stateful Inspection Options
Enable and configure stateful inspection on a WAN interface.
When you create or modify a Connection Profile, the IP Profile Parameters screen allows you to enable Stateful
Inspection on that profile by toggling Stateful Inspection Enabled to Yes. By default, this is turned of f (No). If
you enable Stateful Inspection, the Stateful Inspection Options field appears.
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Numbered
NAT Map List... Easy-PAT List
NAT Server List... Easy-Servers
NAT Options...
Stateful Inspection Enabled: No
Local WAN IP Address: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Filter Set...
Remove Filter Set
RIP Profile Options...
Return/Enter to select <among/between> ...
Configure IP requirements for a remote network connection here.