
Chapter 5. Peripheral Equipment | Section |
|
|
Background Music/Music-On-Hold
Guidelines
•A single music source can be used for both background music (BGM) and
•If a single music source is used for both MOH and BGM, the music source connects to CN5 on the Connector Panel. If separate sources are used, the MOH source connects to CN5, and the BGM source connects to the BGM connector on the SCC card.
•If an FM radio is connected to the BGM connector on the SCC, install it at least 16.5 ft. (5m) away from the main cabinet. If it is too close, the receiver may not function properly.
•The maximum input impedance of both terminals is 10k ohms. The maximum signal level is
•Beginning with
Installation
1.If you are using a single source for both BGM and MOH, connect the source to CN5 on the Connector Panel. If using separate sources, connect the MOH source to CN5 and the BGM source to the BGM connector on the SCC card.
2.Strap the CN5 block
To route the music from ... | Do this ... |
|
|
A single source | Short pin 3 to 2. |
|
|
Separate sources | Short pin 1 to 2. |
|
|
|
|
|
|
DBS Manual - Revised April 2000 |