Section | Appendix A. EX 1.0 Feature Update |
|
|
•The “*71” code will not work if FF3 (ExtPort)# 51# is set to “0”.
•If set to “Analog port RING”, the
•If the phone is in CF/DND
•The incoming ring pattern for the analog device is the same as for the digital key telephone (determined by the Extension Ring Pattern in FF3 (ExtPort)# 39#
Ring Patterns Not Applicable to Analog Device. The following ring pattern addresses will not affect the analog device:
Analog Transfer Ring Pattern | FF1 2# | 1# | 31# | ||
SLT DISA Ring Pattern | FF1 | 2# | 1# | 34# | (0 or 1)# |
Inbound Ring Pattern | FF2 | (Trunk)# 17# |
Flash Interaction. Any disconnect signal sent to the analog port must be greater than the SLT Flash Control; otherwise the disconnect signal will be interpreted as a flash and the call will be placed on hold.
Programming Addresses That Affect the Analog Device. The following addresses will control the analog device, but will not affect the digital key telephone:
AEC Disconnect Duration | FF1 2# 1# 35# |
SLT Flash Control | FF1 2# 1# 11# (0 or 1)# |
SLT Onhook Flash Timer | FF1 3# 14# |
AEC Disconnect | FF3 (ExtPort)# 46# (0 |
or 1)# |
|
Analog Port on | FF3 (ExtPort)# 51# (0 |
or 1)# |
|
Data Security on Analog Port | FF3 (ExtPort)# 52# (0 |
or 1)# |
|
MSG (Message) Key
Description The MSG key on the
•
DBS Manual - Revised April 2000 | Page |