Section 300-Installation | Appendix B. CPC-AII/B 8.0 Feature Update |
| |
•The “*71” code will not work if the other device is in use.
•The “*71” code will not work if FF3 (ExtPort)# 51# is set to “0”.
•If set to “Analog port RING”, the large-display phone will work like an SLT/OPX (no page announcements, no voice calls from other extensions, etc.).
•If the phone is in CF/DND (Call-Forward or Do Not Disturb), the phone will remain in CF/DND even if the ringing device is changed via the *71 code.
•The incoming ring pattern for the analog device is the same as for the digital key telephone (determined by the Extension Ring Pattern in FF3 (ExtPort)# 39# (0-9)#). If this address is set to “0” (determined by CO), the analog device will automatically default to “1 second ON, 3 seconds OFF.”
Ring Patterns Not Applicable to Analog Device. The following ring pattern addresses will not affect the analog device:
Analog Transfer Ring Pattern | FF1 2# | 1# | 31# | (0-6)# |
SLT DISA Ring Pattern | FF1 | 2# | 1# | 34# | (0 or 1)# |
Inbound Ring Pattern | FF2 | (Trunk)# 17# (0-9)# |
Flash Interaction. Any disconnect signal sent to the analog port must be greater than the SLT Flash Control; otherwise the disconnect signal will be interpreted as a flash and the call will be placed on hold.
MSG (Message) Key
44-Series phones only
CPC-AII/B Version 8.0, CPC-S/M Version 2.0, or CPC-EX Version 1.0 only
Description The MSG key on the VB-44225 Large-Display Phone adds the following functionality to the phone:
•Auto-Callback.If a callback message has been left by another extension, you can press the MSG key to place an automatic callback to the extension that sent the message. If more than one callback message has been received, pressing the MSG key will perform auto-callback in the order received.
•Auto-Answer Voice Message. You can press the MSG key to automatically access your voice mailbox. The phone will dial your voice mailbox and send access codes (if programmed) for retrieving new messages.
