Panasonic CPC-EX manual Operation

Appendix A. EX 1.0 Feature Update Section 300-Installation

Analog Adapter Description

Operation

The Analog Adapter (VB-44100) consists of a base adapter and PC board which is installed on the underside of the phone. It is used to connect the 44-Series large-display phone to an analog device such as an SLT telephone, cordless phone, FAX machine, or modem. This allows the same phone line to be used to alternate between normal phone calls and analog communications. (To install, see the instructions supplied with VB-44100).

The first device to go off-hook will seize the line (off-hook is either lifting the handset or pressing the ON/OFF key). If the analog device goes off- hook first, the large-display phone will be unable to dial or go off-hook.

You can choose which device will ring by going off-hook at either the digital key telephone or the analog device and dialing *71. The digital key telephone display will reflect “Analog port RING” or “Key Tel RING”, depending on which device is selected - the default is “Key Tel RING”.

You can still answer an incoming call from either device, regardless of which device is ringing. For example, if the analog device is ringing, you can pick up the call on the digital key telephone by going off-hook before the analog device does. Similarly, if the digital key telephone is ringing or has not answered a voice call, the analog device can pick up the call by going off-hook first.

You can program the *71 ring select command into an FF key. Pressing the key toggles between “Analog Port RING” and “Key Tel RING”. When the analog port is set to ring, the FF key LED lights red. When the key telephone is set to ring, the LED is off.

Notes	Phone Restrictions
	• The Analog Adapter will work on the large-display phone only (VB-
	44225).
	• A dial-pulse SLT will not function on the analog port.
	• Stutter Dial Tone (indicating Call-Forwarding mode, Do-Not-Disturb
	mode, etc.) will not function on an SLT connected to the Analog
	Adapter.
	• An analog phone connected to the Analog Adapter cannot program or
	access speed dials.

Incoming Calls

•You cannot program both devices to ring simultaneously.

•The “*71” code will not work if the other device is in use.

Page A-12 DBS Manual - Revised April 2000 DBS-2.3/9.2-300