Chapter 5. Peripheral Equipment

Section 300-Installation

 

 

Figure 5-10. Cable punch-out plate, Power Failure Unit

3.Mount the PFU on the wall using the three screws provided with the unit. (See Figure 5-11.)

4.Connect the trunks from the central office to the PFU.

5.Connect the SLTs to the AEC extension ports on the PFU.

6.Connect the trunks from the DBS to the PFU.

7.Connect the AEC ports from the DBS to the PFU.

When a power failure occurs, AEC “A” is switched to Trunk “A,” AEC “B” is switched to Trunk “B,” and so on.

8.Connect the +24V and GND terminals from CN2 on the DBS Connector Panel to the PFU.

9.Install the cover on the PFU.

 

 

 

 

5-20

DBS Manual - Revised April 2000

DBS-2.3/9.2-300

Page 114
Image 114
Panasonic CPC-EX manual Cable punch-out plate, Power Failure Unit