
Section | Chapter 4. Trunks and Lines |
|
|
Installing T1 in a Double Cabinet with the T1 in the Slave
1.Install the Sync Unit in the master cabinet as described in Steps 1 and 2 under “Installation for a Single T1.”
2.Install a T1 MDF card in the slave cabinet. (See Step 3 on page
3.Set Switch 1 on the T1 card. (See Step 4 on page
4.Install a T1 card in the “EC/TRK” slot of the slave cabinet.
5.Connect the Sync Cable from CN1 on the Sync Unit to CN5 on the T1 card (Figure
Note: Part Number
6.At the slave cabinet, connect the cable attached to CN3 on the T1 MDF card to CN3 on the T1 card (Figure
7.Using an RJ48 cable, connect CN1 of the T1 MDF card to the CSU. (See Figure
8.At the slave cabinet, connect the ground cable on the T1 MDF card as shown in Figure
DBS Manual - Revised April 2000 |