Appendix A. CM9700-CC1 ASCII Protocol Communication

The CM9700-CC1 provides support of ASCII communication. ASCII data ports, referred to as IDT ports on the CM9700-CC1, interface to ASCII communication devices (ACDs) such as access control systems.

NOTE: When operating in ASCII mode, the KBD200A and KBD300A keyboards can interface to an IDT port of the CM9700-CC1.

When an ACD sends ASCII commands through a CM9700-CC1 IDT port, the CM9700-CC1 executes the commands. Up to 96 ACDs can be connected to the CM9700-CC1 and be configured as IDT ports. IDT ports are configured using the CM9700-MGR.

NOTE: IDT ports eliminate the need for CM9760-DT/CM9760-DT4 devices, which are referred to as external DTs.

The ASCII protocol uses the ASCII character set to transmit and receive commands between an ACD and the CM9700-CC1. The commands are used to control pan and tilt mechanisms (fixed and variable speed), camera functions, auxiliary relays, alarms, multiplexers, VCRs, and system tasks such as macros.

An IDT port communicates in a standard asynchronous, byte-oriented protocol that includes 1 start bit; 8 data bits; odd, even, or no parity; and 1 stop bit.

This appendix provides information about the following:

ACD to CM9700-CC1 connections

ASCII protocol commands supported by the CM9700-CC1

ACD TO CM9700-CC1 CONNECTIONS

You can connect an ACD to the CM9700-CC1 in either of the following ways:

ACD DB9 connection to CM9700-CC1 DB9 (COM 1 or COM 2) via RS-232 communication standard. Refer to the Connecting an ACD DB9 Port to a CM9700-CC1 DB9 Port section for wiring information.

ACD DB9 (RS-232) connection to CM9700-CC1 RJ-45 (RS-422). In this case, the Pelco PV140 RS-232/RS-422 converter is used to provide a bidirectional electrical interface between the RS-232 port of the ACD and the RS-422 port of the CM9700-CC1. Refer to the Connecting an ACD DB9 Port to a CM9700-CC1RJ-45 Port section for wiring information.

CONNECTING AN ACD DB9 PORT TO A CM9700-CC1 DB9 PORT

Connect a DB9 port of the ACD to the DB9 COM 1 or COM 2 port of the CM9700-CC1 using a null modem cable. Refer to Figure 60 for wiring connections. In Figure 60, the ACD connects to the COM 2 port of the CM9700-CC1.

ACD MALE DB9 SERIAL PORT

 

 

 

CM9700-CC1

 

 

36

28

20

12

 

 

35

27

19

11

 

 

34

26

18

10

 

 

33

25

17

9

 

 

32

24

16

8

 

 

31

23

15

7

 

 

30

22

14

6

PRINTER

COM1

COM2

 

 

 

 

 

29

21

13

5

RS-232 NULL MODEM CABLE

NULL MODEM CABLE WIRING

ACD

CM9760-CC1

DB9 PORT

DB9 PORT

PIN 2 = RX

PIN 2 = RX

PIN 3 = TX

PIN3 = TX

PIN 5 = GND

PIN 5 = GND

Figure 60. ACD DB9 to CM9700-CC1 DB9 Connection

110

C1572M (9/05)

Page 110
Image 110
Pelco System 9760 manual Appendix A. CM9700-CC1 Ascii Protocol Communication, ACD to CM9700-CC1 Connections