Pelco System 9760 manual CM9760-RPM Rear Panel Output Card, CM9760-RPM Card Guidelines

CM9760-RPM REAR PANEL OUTPUT CARD

The CM9760-RPM rear panel output card (refer to Figure 52) passes up to 16 video signals from the CM9760-VMC video output card to video output devices such as monitors, VCRs, and matrix switchers. The CM9760-RPM card provides 16 BNCs that connect to video output devices.

UNTERMINATED TERMINATED

	16 VIDEO
	OUTPUT
JP1-JP16	BNCs

SIDEFRAME

CONNECTOR

Figure 52. CM9760-RPM Rear Panel Output Card

As illustrated in Figure 52, the CM9760-RPM card includes the following:

•BNC Connectors (16): Provide the physical connection point for coaxial cable

•Termination Jumpers JP1-JP16: Allow video to be terminated (jumper positions 1 and 2) or unterminated (jumper positions 2 and 3). Note that the termination jumpers on the CM9760-RPM card must always be set in the unterminated position. You must terminate the video signal at the output device, for example, a monitor or VCR. If you are looping to other devices, terminate the last device only.

•Sideframe Connector: Sixteen-pin connector that connects to a coaxial ribbon cable in a sideframe configuration. A coaxial ribbon cable can be used instead of coaxial cable connections to the BNC connectors on the CM9760-RPM card. For additional information, refer to the Sideframing section.

CM9760-RPM Card Guidelines

The following guidelines apply to the CM9760-RPM card:

•The CM9760-RPM card must always be installed into the leftmost slot on the rear of the matrix bay. The leftmost slot provides the connection point to the CM9760-VMC video output card, which is always inserted into slot 17 in the front of the matrix bay.

•The CM9760-RPM must be installed before the CM9760-VMC video output card is installed into the front of the matrix bay.

•Termination jumpers must always be set in the unterminated position.

98 C1572M (9/05)