REPLACING A CM9760-VCC CARD

WARNINGS:

CM9760-VCC video input card replacement should be performed by qualified personnel only.

Electrostatic discharge (ESD) precautions must be observed when replacing a CM9760-VCC card. Always wear a grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.

To replace a CM9760-VCC card, do the following:

1.Remove the front panel of the matrix bay.

2.Remove the CM9760-VCC card to be replaced by grasping the two card handles and firmly pulling the card out of the connectors on the backplane and associated rear panel card. The card slides out of the slot.

3.Install the new card into the slot of the card being replaced (refer to the Installing a CM9760-VCC Card section for installation instructions).

C1572M (9/05)

47

Page 47
Image 47
Pelco System 9760 manual Replacing a CM9760-VCC Card