![](/images/new-backgrounds/1173285/173285193x1.webp)
TERMINATED
UNTERMINATED
IN
OUT
16 BNC PAIRS
JP1-JP16
Figure 51. CM9760-RPL Rear Panel Looping Card
As illustrated in Figure 51, the CM9760-RPL card includes the following:
•BNC Connectors (16 pairs): Provide the physical connection point for coaxial cable. For each pair of BNC connectors, one connector connects to a video source and the other connector connects to the video output device to which the video is looped.
•Termination Jumpers
2 and 3):
–When looping functions are required, the termination jumpers must be set in the unterminated position.
–When looping functions are not required, the jumpers must be set in the terminated position.
The jumpers are set in the appropriate position when your system is configured at the factory. However, if you change your
•Downframe Connector:
CM9760-RPL Card Guidelines
The following guidelines apply to the
•The
•The
•In a bay that is to be fully populated with
–The cards must be installed into odd slot positions only. The corresponding
–The maximum number of video inputs in a matrix bay that is fully populated with
•When installing a new card, termination jumpers must be set in the proper position: terminated or unterminated.
C1572M (9/05) | 97 |