
Figure 27. CM9760-RPM Rear Panel Output Card Installation
5.Push the card into place firmly.
6.Tighten the screw at the top and bottom of the card.
7.Connect BNC cables (or ribbon cable, if applicable).
Replacing a CM9760-RPM Card
WARNINGS:
•Rear panel card replacement should be performed by qualified personnel only.
•Electrostatic discharge (ESD) precautions must be observed when replacing a rear panel card. Always wear a grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.
NOTE: Before replacing a
Unless the audible alarm on the power supply has been disabled, the alarm beeps and the Frame Fault LED flashes red when the
To replace a
1.Ensure that the associated
2.Disconnect BNC cables (or ribbon cable, if applicable) from the
3.Remove the
4.Install the new card (refer to the Installing a
After the
To ensure proper operation of the
44 | C1572M (9/05) |