Pelco System 9760 Connecting Power to the CM9700-CC1, CM9760-HS Port CM9700-NW1, Matrix bays

Table B. RS-422 SERCOM Port Connections in a Single-Node System without a CM9760-HS Hot Switch

Device	SERCOM Port Connection	CM9700-MGR Device Tree Port Assignments
CM9760-MXB(s)	Port 5 and next sequential ports as necessary
Other devices	Any available ports—connections do not have
	to be in sequential ports
Table C. SERCOM Port Connections in a Networked System with a CM9760-HS Hot Switch
Device	SERCOM Port Connection	CM9700-MGR Device Tree Port Assignments
CM9760-HS	Port 5
CM9700-NW1	Port 6—connected through the hot switch
network interface unit
Matrix bay(s)	Port 7 and next sequential ports as necessary—
	connected through the hot switch
Other devices	Any available ports connected through the hot
	switch—connections do not have to be in
	sequential ports
Table D. SERCOM Port Connections in a Networked System without a CM9760-HS Hot Switch
Device	SERCOM Port Connection	CM9700-MGR Device Tree Port Assignments
CM9700-NW1 network	Port 5 on each CM9700-CC1 in the network
interface unit
Matrix bay(s)	Port 6 and next sequential ports as necessary
Other devices	Any available ports—connections do not have
	to be in sequential ports

NOTE: If you add matrix bays to an existing system, you may need to change existing port connections to be able to connect each additional matrix bay to the lowest sequential port possible.

Connecting Power to the CM9700-CC1

To connect power to the CM9700-CC1, connect the supplied 120 VAC or 230 VAC power cord to the power input receptacle on the CM9700-CC1 and to an approved power source.

NOTE: Do not power on the CM9700-CC1 until all system devices have been connected to the CM9700-CC1 and all system devices have been powered on.

20 C1572M (9/05)