
INSTALLING OR REPLACING A CM9760-DFC DOWNFRAME CARD
The
Installing a CM9760-DFC Card
WARNINGS:
•Rear panel card installation should be performed by qualified personnel only.
•Electrostatic discharge (ESD) precautions must be observed when installing a rear panel card. Always wear a grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.
NOTE: A
To install a
1.Set termination jumpers
•When
•When
UNTERMINATED
3 2 1
TERMINATED
JP 1
JP 16
Figure 22. Termination Jumpers on CM9760-DFC Downframe Card
2.Locate the desired slot position at the rear of the bay.
3.Remove the blank cover plate by loosening the screw at the top and bottom of the plate.
4.Slide the new card into the card guides (refer to Figure 23).
C1572M (9/05) | 39 |