LCD | Description | Corrective Action | |
Code |
|
| |
214 | Invalid Slot Config. The Max- | Change the Max Addressable Slot to a value greater | |
| imum Number of Slots is set to | than 1 (see Setting the Max Addressable Slot Option in | |
| 1 and the last slot is config- | Chapter 3) or turn off the Clean Slot Option (see Setting | |
| ured as a cleaning slot. | the lean Slot Option in Chapter 3). | |
|
|
| |
220 | OS failure. The library’s oper- | Make sure the library and tape drives are not being used | |
| ating system experienced an | by any host, then reset the library from the operator | |
| error. | panel. | |
|
| If the error persists, contact your service provider. | |
221 | Could not set alarm. The | ||
| |||
| library’s operating system |
| |
| experienced an error. |
| |
|
|
| |
222 | OS message failure. The |
| |
| library operating system expe- |
| |
| rienced an error. |
| |
|
|
| |
225 | M Bus Timeout. No acknowl- | Ensure no commands are active to the library. Reset the | |
| edgement from internal M bus | library. If error persists, contact your service provider. | |
| device |
| |
|
|
| |
226 | Mbus interrupt timeout. The | Make sure the library and tape drives are not being used | |
| robot command processor | by any host, then reset the library from the operator | |
| timed out before setting an | panel. | |
| interrupt. | If the error persists, the robot may need to be replaced. | |
|
| Contact your service provider. | |
227 | Mbus acknowledge failure. | ||
| |||
| The robot command processor |
| |
| failed to respond to a com- |
| |
| mand. |
| |
|
|
| |
230 | DHCP server timeout. The | This error occurs only when the optional Ethernet inter- | |
| Ethernet DHCP server could | face is installed. Set the network address to Static and | |
| not assign an IP address for | set the desired IP address (see Setting Ethernet | |
| the library. | Addresses in Chapter 4). | |
|
|
| |
236 | SCSI Configuration Error. | If power cycling the library does not recapture this infor- | |
| Configuration start ID is | mation, contact your service provider. | |
| invalid. |
| |
|
|
| |
237 | SCSI Configuration Error. |
| |
| Configuration field is invalid. |
| |
|
|
| |
238 | SCSI Configuration Error. |
| |
| Configuration value is invalid. |
| |
|
|
| |
239 | SCSI Configuration Error. |
| |
| Configuration buffer ID is |
| |
| invalid. |
| |
|
|
|
Appendix C Page 129