Plasmon V15 manual Configuration Description Option

Table 4. Library Configuration Options

Configuration	Description
Option
SCSI Menu:
SCSI IDs	Setting SCSI IDs is required for library operation. View the default
	settings and change them if necessary.
Emulation Mode	Setting an emulation mode is required if your application software
	does not support a Plasmon V15.
SCSI Parity	By default, parity checking is enabled. If desired, you can disable
	parity checking for the library if the SCSI adapter card connected
	to the library does not support parity checking.
Configuration Menu:
Baud Rate	Setting a baud rate is only required for communicating over the
	serial port for firmware upgrades and diagnostics. You do not need
	to set this option for normal library operations.
Clean Slot	These three options allow you to set up automatic tape drive
Autoclean	cleaning.
Clean Cycles Left	Note: To use automatic cleaning, a cleaning cartridge must be
	installed.
POST Barcode Scan	If your software application does not automatically scan barcode
	labels when the library powers up or when the door is opened and
	closed, you can set this option so the library automatically scans
	the labels. By default, this option is turned off when the library is
	shipped.
	Note: If your library does not include a barcode scanner, the LCD
	shows “N/A” after the option.
Verify Barcode	This option instructs the library to look for barcode labels with
Checksums	checksum characters. If you plan to use barcode labels that
	include checksum characters, you should enable this feature. By
	default, this option is turned off when the library is shipped.
	Note: If your library does not include a barcode scanner, the LCD
	shows “N/A” after the option.
Security Menu:
Security	By setting security, you prevent unauthorized personnel from dis-
	rupting the operation of the library through either the LCD keypad
	or the SCSI bus.

Plasmon V15 AIT Tape Library User Manual Page 38