The following diagram shows the element index assignments for the library.

 

 

 

 

 

 

 

 

Fixed Cartridge

 

 

Tape Drive

 

 

 

 

 

 

 

 

 

 

Slots

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

11

 

12

 

13

 

14

 

15

 

 

 

 

 

 

82

 

 

83

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Robot

86

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Magazine

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

10

9

 

8

7

6

5

 

4

 

3

 

2

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 25. V15 Element Indexes

Element Addresses

Your application software may use element addresses to identify elements in the library. The difference between an element index and an element address is that an index is a fixed number set in the library’s firmware, whereas an address can be changed by your application software (using the SCSI command,

MODE SELECT).

The library’s default element addresses correspond to the element indexes.

Using the Demo Menu

The Demo option causes the robot to randomly move cartridges from slot to slot, including the fixed cartridge slots.

To run the demo option:

1.If necessary, disable security.

2.Change the robot mode to LCD.

3.Make sure there is at least one cartridge present and one empty slot before you begin the test.

4.From the operator panel keypad, press [MENU] to display the menus. Press the down arrow key until “Demo Menu” displays, as shown below.

D e m o

M e n u

Library Operation Page 67

Page 69
Image 69
Plasmon V15 manual Using the Demo Menu, Element Addresses