WARNING

Before performing any installation or maintenance procedures, be sure that the library power switch is in the off position and that the power cord is disconnected from the library and the outlet.

WARNUNG

Vor der Ausfuhrung von Installations- oder Wartungsarbeiten ist daraufzu achten, daß der Library-Netzschalter auf ”Aus” gestellt ist und daß das Anschlußkabel non der Library und der Steckdose entfernt ist.

ATTENTION

Avant de procéder a l’installation ou a l’entretien, vérifiez que l’interrupteur d’alimentation de la librarie se trouve en position “arret” et que le cable d’alimentation ne soit pas branché a la librairie et a la prise de courant.

Preparing and Installing Cartridges

This section describes how to remove the packing material from the cartridge magazine, prepare cartridges for use in the library, and install cartridges in the fixed slots and in the magazine.

Preparing Cartridges

1.If your library includes a barcode scanner, you can affix barcode labels to the cartridges. To do this, position the label using the ridge on the cartridge for guidance, as shown below.

Barcode Label

Figure 9. Barcode Label Placement

NOTE

To ensure barcode labels are read accurately, use labels with checksum characters. Also, make sure the Verify Barcode Checksums option is turned on.

Hardware Installation Page 25

Page 27
Image 27
Plasmon V15 manual Preparing and Installing Cartridges, Preparing Cartridges