Plasmon V15 manual Safety Agency Standards, FCC Notice, Laser Safety Notice

Safety Agency Standards

The Plasmon V15 library complies with the following domestic and international product safety standards:

•UL Standard 1950, 2nd Edition: 1995 Safety of Information Technology Equipment.

•CSA Standard C22.2 No. 950-95, Safety of Information Technology Equipment.

•EN 60950: 1992 +A1 +A2 +A3 +A4 +A11, Safety of Information Technology Equipment.

FCC Notice

NOTE

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Shielded cables are required for this device to comply with FCC Rules. Use shielded cables when connecting this device to others.

Laser Safety Notice

This library has a laser scanner bar code reader inside the housing which complies with 21 CFR 1010.10, 1040.11, and IEC 60825-1:1993 +A1+A2, and EN60825-1:1994 +A11+A2, Safety of Laser Products Part 1: Equipment Classification, Requirements and User’s Guide, as a Class 1 Laser product.

WARNING

Removing a drive or access panel with the library powered on may result in exposure to the 650 nm, 1.2 mW Class 2 pulsed radiation laser scanner. Always power off the library and remove the AC power cord before removing or installing an access panel or drive.

Caution. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

Plasmon V15 AIT Tape Library User Manual Page 2