Troubleshooting

Symptom

Cause and/or Corrective Actions

The title search function does not work.

• The tape has no cassette memory.

cUse a tape with cassette memory (p. 154).

•CM SEARCH is set to OFF in the menu settings.

cSet it to ON (p. 105).

•There is no title in the tape.

cSuperimpose the titles (p. 96).

•The tape has a blank portion in the recorded portion (p. 154).

The new sound added to the

• AUDIO MIX is set to ST1 side in the menu settings.

recorded tape is not heard.

c Adjust AUDIO MIX in the menu settings (p. 105).

The title is not displayed.• TITLE DSPL is set to OFF in the menu settings.

cSet it to ON in the menu settings (p. 105).

•Screen indicators are displayed on the screen.

cMake the screen indicators disappear (p. 36).

In the recording and playback modes

Symptom

Cause and/or Corrective Actions

The power does not turn on.

• The battery pack is not installed, or is dead or nearly dead.

 

c Install a charged battery pack (p. 13, 17).

 

• The AC adaptor is not connected to the mains.

 

c Connect the AC adaptor to the mains (p. 18).

The end search function does not

• The tape was ejected after recording when using a tape without

work.

cassette memory (p. 33, 39).

 

• You have not recorded on the new cassette yet (p. 33, 39).

The end search function does not

• The tape has a blank portion in the beginning or middle

work correctly.

(p. 154).

The picture does not appear in the

• The LCD panel is open.

viewfinder.

c Close the LCD panel (p. 25).

 

• When the viewfinder is not pulled out until it clicks, the picture

 

does not appear in the viewfinder.

 

c Pull out the viewfinder until it clicks (p. 22).

The battery pack is quickly

• The temperature of the environment is too low.

discharged.

• The battery pack is not fully charged.

 

c Charge the battery pack fully again (p. 13).

 

• The battery pack is completely dead, and cannot be recharged.

 

c Replace with a new battery pack (p. 17).

The battery remaining indicator does • You have used the battery pack in an extremely hot or cold

not indicate the correct time.

environment for a long time.

 

• The battery pack is completely dead, and cannot be recharged.

 

c Replace with a new battery pack (p. 15).

 

• The battery is dead.

 

c Use a charged battery pack (p. 12, 15).

The power goes off although the

c Charge the battery pack fully again so that the indication on

battery remaining indicator indicates

the battery remaining indicator is correct (p. 13).

that the battery pack has enough

 

power to operate.

 

 

 

 

(continued on the following page)

χˆËя￿ËÌÙÓ ДÓÔÓÎÌËÚÂθ̇я Information Additional

161