Tutorials
AWG710&AWG710B Arbitrary Waveform Generator User Manual 2-63
Tutorial 4: Editing a Waveform Using Quick Editor
Quick editor is a function that lets you simultaneously edit and output a w av eform.
When you open the quick editor, the w a ve fo rms in t he qu ick e dit or a re c omple tely
independent of the waveform editor . When you e xit from the qui ck editor, you can
select whether to save or cancel the changes.
In this tutorial you will learn the following:
How to enter into the quick editor
How to edit a waveform
How to save the changes in the waveform editor
Preparation Do the following steps to set the instrument to the factory def ault set tings and load
a sample waveform:
1. Reset the instrument to the factory de fault settings. Refer to page 2-56.
The SETUP menu screen appears.
2. Load the waveform LIN_SWP.WFM from the sample waveform floppy disk.
Refer to Tutorial 1 for how to load a waveform file from a floppy d isk.
Open the Quick Editor Do the following to open the quick editor:
1. Push the Edit... side button for editing the waveform in the waveform editor.
The Waveform Editor screen appears, as shown in Figure 2-40.
2. Push the front–panel QUICK EDIT button.
When you enter into the Quick Editor, the bottom menu buttons are disabled
and the Quick Editor side menu is displayed.
NOTE. Y ou can enter the quic k editor only fr om the wavefor m editor. First you open
a file in the waveform editor, and then you enable the quick editor mode.