Tektronix AWG710, AWG710B Sequence Table Editing

The Sequence Editor
3-120 AWG710&AWG710B Arbitrary Waveform Generator User Manual
Sequence Table Editing
This section describes the sequence table editing.
Cursor Movement The cursor moves on a cell–by–cell basis. The following text describes how to
move the cursor. The instrument highlights the active cell.
Move the cursor up or down a line by using the general purpose knob, the y
and b buttons, or the keyboard keys.
Move the cursor horizontally along a line by using the a and ' buttons or the
keyboard keys.
You can also move the cursor by entering numeric values. This is convenient,
for example, when a long sequence results, because more rapid cursor
movement is implemented.
Push the Move Cursor to bottom button to display the Move Cursor to the
dialog box. Input the destination line number in the dialog box, and then push
the OK side button.
When you set the value in the Repeat Count, the a and ' buttons are assigned
to shift the numeric values. To move the cursor horizontally, push the
TOGGLE or CLEAR MENU on the front–panel. Use the a and ' button to
move the cursor.
The side menu corresponding to the Data Entry bottom button varies with the
parameter value in the cursor position.
Inserting a Line When you first open a new sequence table, a table containing 0 lines is created. You
must insert new lines into the table before you can edit the co ntent s. To insert new
lines, use the Insert Line command as follows:
1. Move the cursor to the position that you want t o insert a new line. If this is a
new table, you are already at the place to insert a new line.
2. Push Data Entry (bottom)!Insert Line (side).
A new line is created immediately abov e the l ine of the curr ent curs or posit ion.
If you insert a new line into a table that con tains line jump numbers , the instrument
automatically updates the table l i n e numbers and the jump line number s.
NOTE. The maximum number of lines in a sequence table is 8000.