Tektronix AWG710, AWG710B Moving the Cursor, Renewing Edit Buffer, About Undo

Quick Editing
3-104 AWG710&AWG710B Arbitrary Waveform Generator User Manual
Moving the Cursor
During execution of Quick Edit, you can change the target area for editing, by
moving the cursors. When you use one of the four VERTICAL/HORIZONTAL
knobs; the general purpose knob and the numeric keys remain assigned to change
the value. To move a cursor, press the TOGGLE button on the front–panel before
operating the general purpose knob or numeric keys.
Follow the steps below to move the cursor:
1. Press the TOGGLE button on the front–panel to assign the general purpose
knob to cursor movement.
2. Set the cursor position using the general purpose knob or numeric keys.
Renewing Edit Buffer
During execution of Quick Edit, you can combine the four VERTICAL and
HORIZONTAL knobs and the general purpose knob for the operation purpose.
Each time you operate any of the knobs, the following i nternal c alculat ion is made
to renew the waveform data:
The cursor–to–cursor data is defined as the object of calculation with respect
to the waveform that was obtained when you start Quick Edit.
Using the current Vertical Scale, Vertical Offset, Horizontal Scale, and
Horizontal Offset values, the calculation is made in this order with respect to
the cursor–to–cursor data.
Smoothing is executed.
About Undo
The undo buffer is used for waveform backup, so t he Quick Editor does not support
the Undo! function. Before exiting Undo!, you are asking whether to reflect the
changes to the waveform. To cancel the changes, selec t No.