The Sequence Editor
AWG710&AWG710B Arbitrary Waveform Generator User Manual 3-127
To enable or disable Strobe functionality in the Event Jump screen, push the
Strobe side menu button to toggle between On and Off. The strobe sett ing is sav ed
in the sequence file as an attribute, and used when the sequence is executed. You
cannot change this setting while a sequence is being performed.
Figure 3-32: Event signal timing and strobe
Software Jump Software jump can be performed only with the command using a GPIB or Ethernet
interface. When you specify a line number as an argument in the command line, the
control in the currently loaded sequence file will jump to the specified line.
To perform a software j ump, the mod e must be s et in the loaded sequence f ile. Th is
can be set in the sequence editor by pushing:
Jump Mode (bottom)!Software (side)
Two internal
clock cycles
The instrument reads this state in an unstable
transition period. This may cause an erroneous action.
The instrument reads this state after
the transition has completed.
Strobe Off
STROBE
Strobe On