CONNECTING A SCSI HARD DISK
488
■Phaser Copystation:
■If you have a Phaser Copystation connected to the printer, it must be
located at one end of the SCSI chain, with the printer at the other end
and the external disk(s) in the middle.
■The Copystation uses two SCSI ID addresses, 5 and 6; therefore, the
external disk(s) can use ID numbers 0 through 3. If you set an external
disk to SCSI ID address 5 or 6, you may see an error on the
configuration or startup pages.
■
Sys/Start
file:
■You may load a startup file called
Sys/Start
onto your external disk. The
Sys/Start
job file is similar to an init file. When you turn on the printer
the file executes, providing that
Sys/Start
has been enabled through a
control file downloaded to the printer. Refer to Enabling and disabling
SysStart Job execution for more information.
NOTE
If the
Sys/Start
file contains an error, the printer ignores the remainder of the file and
may not start up as expected.