SYMPTOMS AND SOLUTIONS
610
Print job does
not finish (the
printer times out)
If you are using the serial or parallel port from a PC, make sure that you used
the MODE command to set the PC’s communication parameters. For
example:
MODE LPT1:,,P > NUL
MODE COM1:9600,N,8,1,P
The P parameter in these commands sets the port timeout to Infinite Retry
and must be part of the command.
If you are using Windows 3.1 or Windows 95, make sure that the
Transmission Retry value for the printer’s assigned port is set to 950. For
more information, see Printing from a PC then select your driver.
Error indicator is
blinking The Error indicator blinks with any hard error, such as media jam or door
open.
Look at the front panel for an indication of the type of error, then correct the
problem. If the front panel message is Service Required/Fault Code:xx, make note
of the fault code number, then turn the printer off and on again. If the Error
indicator remains on after power-up, your printer requires service. See If you
need help for telephone information.
If you can’t make a print (cont'd.)
Symptom Solution